Fuses: Device used as electrical protection. It limits the electrical current that flows through a circuit.
Read more
They can be identified with a number that states the maximum current they can withhold. Once this current is surpassed (due to an overload or a short-circuit), the fuse breaks down and interrupts the flow of the current. The location and function of each fuse is stated in the owner's manual of the car or in the plastic lid of the fuse box.
Wipers do not work, will not move or anything? The monkeys pump works,washer fluid, bur nothing. Checked out all the fuses and replaced them was told to check the wiper relay but having a hard time finding it? I was told several places to check but haven't checked under the dash on the driver's side because I have to pull the whole dash apart? Is there a way to take the fuse block out from the left side dash? Was told it might be able to get to it?
Well I replaced both of the wiper relays and the multifunctional swich but still no wipers. I have power to the wiper motor but they don't move. Now when I turn the wipers on the headlights come on? So I don't know what elae to do. Maybe replace the wiper motor? Any suggestions from anyone.
I have a new BCM from the Chevrolet dealer but its not in the truck yet because it needs to be reprogrammed. I talked to a serves technician and that's the problem.
I noticed my headlights on a few hours after I got home. Thankfully my battery was not dead yet, but I can't get them to turn off! My husband pulled the fuses and relays (I think that's what he said they were). They still stayed on!! He finally disconnected the battery. Please help!!
Old battery went completely dead, changed it and now I don't have any turn signal noise, door chime, and my radio isn't turning on. I checked every fuse possible and still nothing, any idea what could be the problem?
First, check if there's any loose connector near the battery or semething damaged. I dont´t know Silverado, but maybe there's a sort of BCM or electronic module that controls all you mention.
I HAVE A PROBLEM WITH A CHEVROLET SILVERADO 2019 RST Z71 5.3, THE HEADLIGHTS,TURN SIGNALS WORKS FINE, BUT ON THE REAR LIGHTS JUST WORK THE STOP AND TURN SIGNAL, THE PARK LAMPS WONT WORK BUT THE LICENSCE PLATE WORKS FINE, I CHECK THE FUSES AND ARE FINE, BUT AT THE TIME TO CHEK THE RELAY PARK LAMPS , I CONNECT THE TESTER LIGHT TO GROUND AND I MAKE A BRIDGE TO RELAY GROUND AND PARK LAMPS TURN ON, SO I SCANNED THE BCM AND NO FAULT CODES, I CHECK ON DATA LIVE AND THE SWITCH WORKS ACTIVE AND INACTIVE, ANY ONE HAS THE SAME PROBLEM
I recently had an issue with the Battery Distribution Engine Compartment Fuse Block (see pic)
Truck would not start. Zero power. As a quick fix we jumped two of the terminals and that got it started. However, I have no running lights. Everything else works including headlights, brake light and blinkers. Because the Battery Distribution Engine Compartment Fuse Block will not arrive for a few days and I need to drive in the evening, I was hoping a mechanic could tell me if there is a temp fix by maybe jumping the terminals while I wait for the part to arrive. I currently have a 30 Amp inline fuse fuse so the truck will run. Please help
I just replaced my head gaskets intake manifold gaskets put completely back together cranks over but will not start I checked all my fuses and the fuse box underneath the hood I checked all my fuses on driver side side panel I had one fuse blown that was a 20 amp fuse and it on my description for the fuse it said crank I replaced it I still have no start
Brakes lights went out at the same time. I have checked all known fuses, changed all bulbs, changed brake light switch, checked wires, cleaned all wiring
My truck is not getting fuel pressure to turn on and I had to get a new fuse box and these 2 middle harnesses are melted a lil bit on corner! Wondering if that could be the reason why there is no fuel pressure ?
No click no nothing, won't hold charge, clicking in fuse box area, mirror lights flashing, flashers off, dome lights flashing, lights off, no key in ignition
Has brand new starter alternator and distributor cap And a brand new battery. I did notice the crank fuse is gonna be and there is no pin for it in the fuse panel either.
Everything was working when my boss let me use it for work now my tail lights gas gage are not working now and my signal lights come on at same time my break lights work all fuses are good i think its the sencers but cant findnthen where are them
Towed cattle trailer one evening & all trailer lights (LED) worked fine. Backed into drive & shut off. Next morning, used remote start. Vehicle started & vehicle lights came on, but no trailer lights now. Fuses 1, 4, 7, 11, & 26 all good via ohmmeter. No trailer clearance & running lights. No L or R trailer signal lights. No trailer brake lights. Remote start works fine on vehicle as do brake, tail, head lights, & turn signals. Any suggestions???