Stalls
Nissan Pathfinder 2004 115000 miles
It has happened twice to me that when I accelerated my car deeply, it stalled. When I turn it on again, after 2 seconds it stalled once more. Even worse, when I finally worked out how to hold it turned on, it wouldn't go over 2500 rpm as it entered in a short circuit. I was told the problem might be with the maf sensor, what do you think? What can I do to avoid this happening again? Thank you in advance.
1 report
2
MA
I had your same problem and to know whether it is a MAF failure, you should check the oxygen flow in order to create a perfect mix of fuel and oxygen and thus have a good burning. You can as well check the internal resistance of your vehicle. In my case, once I replaced the MAF sensor, it started working perfectly again.
Vote helpfulRelated problems
Car stalling
Pathfinder 2007 My car stalls why'll braking or almost coming to a complete stop
Stalls when driving
Pathfinder 2006 I have a Nissan Pathfinder which stalled when driving and it didn't start again. The fuel pump has been replaced and the engine could be started but the problem unluckily returned. I was told the caus…
1 replyPower loss and stalls
Pathfinder 2014 Since my car reached 10000km, it has been presenting several problems: power loss, tries to stall and even jerks. It is dangerous to drive it at low speeds. No solution has been yet found.
1 replyStalls
Blazer 1991 The engine stalls when braking or turning the car.
2 repliesStarts then stalls
F-150 1998 ford F150 truck 8cyl 302The truck will start but then stalls. If I hold down the accelerator it will start and keep running.
Shivers and stalls
Cerato 2007 I own a Kia Cerato 2007 and its problem is that, when starting the engine, it maintains the idle speed for a while but then starts shivering until it stalls. If I try to accelerate it, the car does no…
2 replies
Did you find the website helpful?
Thank you!