When you put the key in ignition and turn to start the car will not start,you turn the key to off and remove the key all the dash lights stay on only way to turn them off is disconnect the battery. We can start the car with a wire from battery to starter relay but it will not switch off and carries on running even with key out so we have to pull the battery lead off or unplug the ignition switch. The ignition switch and ignition barrel have been replaced but this has not solved the problem. Any help will be appreciated

I got this car used. It's power windows went out along with the 4 wheel drive lights high aand low blink six times and the dome lights along with vanity mirror lights do not work. This all broke on the same day. No blown fuses. Relay tests SOUND like they are fine. I an not fIne a wiring diagram thAt will show all these systems on the same circuit. What can I do.

It started with the turn signals I change the fuse for the turn signals three times within 2 days. Then all of sudden the hazards and turn signals weren't working but the fuse was fine. I tried looking stuff up on the internet at that moment and seemed mentioning of I believe it's called the hazard relay but it's under the dash directly above the OBD2 hook up. So I unplugged it, took it off took it into AutoZone to see if they had a new part and I was just going to buy a brand new relay to to replace it. But they didn't have one so I took the old one back out plug it back up and all of a sudde… Read complete

I bought a 2001 Ford explorer XLT not running. The transmission had been replaced, and it ran before the transmission was pulled. After the transmission has been installed it would not start back since then the pump has pretty much rotted off into the tank. I replaced the pump, but do not have power to the pump or the safety switch I can bypass the relay and the pump will run so I'm not getting power to my relay what do I do? After being prompted to enter my mileage on this but I realize that it does not show mileage on the instrument cluster it just has dashes

Battery is good. Lights come on. I can bypass the starter relay and engine will crank, but still won’t start. I switched relay switches and it made no difference.

My 97 ford explorer XLT w 5.0 and all options except cruise control, has a intermittent electrical problem, it starts fine and charges fine then sometimes the starter solenoid just clicks or the alternator will not charge, I have replaced the ignition switch, starter relay, solenoid and starter, and replaced the alternator checked all fuses and it works as it should sometimes and then will not start or not charge when it starts any help would be greatly appreciated

No power to the PCM no check engine light on when key is in the on position relay's and fuses good OBD 2 can't make connection

I have changed the battery and the starter because my car sometimes starts and then wont start. I've wiggled the ignition and the tilt steering wheel to check if it was the ignition and it started. Then i turned car off and next day would not start again. I haven't gotten the car to start again since. Maybe relay?

Tried to fix rear upper brake light light still don't work but now it won't go in gear is it a fuse or relay please help