Stalls out while driving at low rpm , changed alternator, battery and 2brand new fuel pumps and still stalls , getting worse, before temp gets up it seems to run A ok ???? Please help !!

My silverado idles extremely rough and stalls out when i press on the gas i can sometimes keep it running but barely does anyone know what it could be

On the diagram it’s calling for relay number 43 but in my fuse panel there is not one that exists. It’s just empty in that location.

I have no sound after installing a aftermarket radio

Changed steering colum now wont start

Truck once warm will studer and fie or just die wait a few minutd and it will stsrt. Then sfter a few minutes it does it agai have changed coil icm plugs wires distributor cap and module. Also throdle position censpor cleaned throttle body. Could my catilatc converter by baf. Help have to go to work tomorrow.

Ok I went to start my truck today and then a few seconds later it died. I tried this few more times with the same result. Charged it and still did the same thing. It was acting like it wasn't getting any gas. I've been told it could be the fuel pump or several other things what could it be any and all help would be really helpful.

Put a new ignition switch,no security displays battery,starts for 3 secs. Then dies

My truck stalls some and as much as you can press the gas it only maxes out at about 2000 rpms. Any suggestions on how to increase power ?

I was pulling trailer and my brake system light came on then it died. It will not start doesn't even try to start. Brake system light is on security light and battery light is on. With key off all my gages and running lights stay on

I turn the key and it starts then dies

Changed fuses, attached, factory wiring for aftermarket trailer breaks, I have power to trailer fir lights, turn signal, but still no power to trailer breaks ? Trying to install a break control, can not find an adapter that will not require me to cut wires .

My truck, although it had a hitch and all the trailer light connectors and such, both multi prong and 4 prong options, but it did not come equipped with a trailer Break Controller... I ordered a OEM original trailer break controller, and customized the panel to a perfect fit, there was a cable connection that is for the trailer brake controller behind the panel and plugged in a dummy hole, (since I didnt have that option equipped I only had a little change pouch in the panel... I cut it out, custom fit for the OEM controller, the connector for it via the cable that was already there in place (… Read complete

Engine died en route. Battery fine but sounds like fuel starved.

I was pulling trailer and my brake system light came on then it died. It will not start doesn't even try to start. Brake system light is on security light and battery light is on. With key off all my gages and running lights stay on

I replaced fuel pump relay ,fuel pump,fuel filter put a new battery in it the first time i tried to start it it made a spinning noise like sumthing wasnt cat hing i tried again this timeit tured over but wount start and the battery died i tried to boost it turned the key nothing tryed to charge it n the same thing wont turn over all the accsessery work dont kno were togo crom here dont want to keep tbrowing money at it