Ignition control module problems

Top problems

No start no power to coil or fuel shutoff switch or Ignition module

Ford F-150 1992 4.9 manual  135000 miles
The truck will crank but has no power to coil ignition module or fuel shutoff switch (inertial) we hav jumped between 2 and 6 in the eec connector and still no power to switch checked main ignition switch and all wires have power in the run position found a bad wire to main fuse panel under hood to the # 22 fuse repaired and restored power. Had ignition mod. Tested used noid light on injectors verified spark replaced all 6 injectors verified base timing and plug wire location HAVE Questions about noid light test seems the light is blinking way to fast when cranking like its seeing every cylinder pulse signal not just the one I am connected to ???
stumped from United States 8 years ago  
ST
8 reports 

Crank but no start. No spark to any coils

Ford F-150 2007 5.4 triton 3 valve 168000 miles
Hello I have a 07 f150 that died out at the light and would not restart. Replaced battery which was 9 years old and done for. I have checked fuel which I’m getting it is reading at range on scanner. Crankshaft, cam sensors are good. Ignition module is good, I checked fuses believe all the ones I needed. Swapped pcm fuse with another. I I have no spark to any cylinder. Starting fluid did nothing as well. Will crank but not start.
Cody from United States 5 months ago  
CO
9 reports 
Problems with a F-150? Share them
Submit commentCancel
Submit replyCancel


Did you find the website helpful?

Thank you!