Started just fine, back out of driveway, when I was pushing on the accelerator it acted like it didnt want to go. Finally died. Tried to get it to turn over again and it just tries to start but wont.

New plugs, new coils. Im getting the notorious p300 code. If speed limit is 55 ill get to speed and then try to maintain 55mph lightly on the gas pedal... Ca -put ca- put put!! The misfire happens. Get on gas a bit more and it stops! Ive almost had it with this F.O.R.D 5.4 3v nightmare! Help!! Please

Ok so ill be driving amd everything will be ok untill i slow down to a stop then it idles very low so low it stalls it doesn't do it all the time but mostly when i put it in reverse... the only reason i think it does it in reverse more is because it has the most torque so you dont have to use as much of the gas pedal to get it going which results in the low idle stalling... i replaced the crankshaft position sensor and cleaned the maf sensor... any info would help please and thank you

Driving along at normal speed (35) truck starts losing speed, step on the gas pedal a couple of times, nothing and still losing speed, throw the shifter into neutral and step on the gas pedal 2 or 3 times, throw it back into drive and everything is fine. Has happened to me 3 times and it has been once for each year and for three years. Dealership unable to find anything wrong and have no idea when it will happen again. Anyone Else????

My truck on cluster a green wrench appears and it loses its power when driving and it wont gain power when push on gas pedal also speedometer drops to zero and stays there. Sometime it will go off and go back to normal for a minute or 2 but right back to the same issue. I turn it off for a minute and it will real reset back to normal but five minutes later it does it again.